Wear of turning tool during machining of steels used in surgical instruments

Magdalena Zawada-Michałowska , Paweł Piesko , Jerzy Jóźwik , Andrzej Łukaszewicz


The purpose of the paper is to present the design of a new plastic part and injection process simulation. Workflow in virtual modelling and simulations in CAx system was presented on an example of the trolley plastic car for kids. The model of the plastic car was designed and simulated to determine the injection parameters in SolidWorks environment. Based on the 3D model of the product the mould tool was created. From the virtual testing the most suitable injection point location, material temperature as well as the fill time and required injection pressure have been specified. With these results the designers can avoid anomalies or defects in real plastic things with the actual injection process parameters, like: air traps, weld lines and sink marks. Such analyses allow the designer to develop a proper mould 3D model, to save the mould setup time as well as to reduce the cost for manufacturing the mould.
Author Magdalena Zawada-Michałowska
Magdalena Zawada-Michałowska,,
, Paweł Piesko
Paweł Piesko,,
, Jerzy Jóźwik
Jerzy Jóźwik,,
, Andrzej Łukaszewicz (FME / DMDTE)
Andrzej Łukaszewicz,,
- Department of Machinery Design and Thermal Engineering
Publication size in sheets0.5
Book 18th International Scientific Conference: Engineering for Rural Development, 2019, Latvia University of Life Sciences and Technologies , 2000 p.
Keywords in English injection moulding, mould design, plastic parts, CAx, SolidWorks
URL http://tf.llu.lv/conference/proceedings2019/Papers/N401.pdf
Internal identifier000045767
Languageen angielski
LicensePublisher website (books and chapters only); published final; Other open licence; with publication
Score (nominal)0
Score sourceconferenceList
ScoreBUT score = 15.0, 20-09-2019, manual
Ministerial score = 0.0, 14-02-2020, ChapterFromConference
Citation count*1 (2020-04-02)
Share Share

Get link to the record

* presented citation count is obtained through Internet information analysis and it is close to the number calculated by the Publish or Perish system.
Are you sure?