Comparison of different magneto-rheological fluids’ stability

Joris Vėžys , Egidijus Dragašius , Kazimieras Juzėnas , Evguenia Korobko , Arkadiusz Mystkowski


The purpose of this paper is to compare two different methods for describing the sedimentation in different MRFs. It was decided to obtain electric resistivity of the MR fluid under magnetic field and to measure inductance of the solenoid, which is around the MR fluid, for diagnostic of the sedimentation. The electrical resistivity of the MR fluids and inductivity of the solenoid was measured daily for 11 days for 5 different MR fluids: (Lord MRF-140CG, Lord MRF-122EG, Liquids Research Company MRHCCS4-A and Liquids Research Company MRHCCS4-B and MUDZH-3 made in A. V. Luykov Heat and Mass Transfer Institute, Minsk, BY). These two methods and according procedures are described below.
Author Joris Vėžys
Joris Vėžys,,
, Egidijus Dragašius
Egidijus Dragašius,,
, Kazimieras Juzėnas
Kazimieras Juzėnas,,
, Evguenia Korobko
Evguenia Korobko,,
, Arkadiusz Mystkowski (FME / DACR)
Arkadiusz Mystkowski,,
- Department of Automatic Control and Robotics
Journal seriesJournal of Measurements in Engineering, ISSN 2335-2124, e-ISSN 2424-4635, (0 pkt)
Issue year2019
Publication size in sheets0.5
Keywords in Englishmagneto-rheological fluid, electric resistivity of MRF, inductance of solenoid, sedimentation of MRF
Internal identifierROC 19-20
Languageen angielski
LicenseJournal (articles only); published final; Uznanie Autorstwa (CC-BY); with publication
Score (nominal)5
Score sourcejournalList
ScoreMinisterial score = 5.0, 11-03-2020, ArticleFromJournal
Citation count*
Share Share

Get link to the record

* presented citation count is obtained through Internet information analysis and it is close to the number calculated by the Publish or Perish system.
Are you sure?